Avery 9825 Uživatelský manuál

QUICK REFERENCE This Quick Reference contains supply loading and general care and maintenance procedures for the Monarch® 9825® printer. For more det

You may need to clean the printhead, sensor, and platen roller: ♦ if there is any adhesive build-up in the supply path. Voids ♦ after printing appro

6. Moisten another cotton swab with isopropyl alcohol. Rub the cotton swab across the printhead and remove any build-up. You may need to use a prin

Troubleshooting This section lists common problems and their solutions. For more detailed information, refer to the Operator’s Handbook available on

Common Errors If the action does not resolve the problem, call Service. Error Description/Action002 Name must be 1 to 8 characters inside quotes. 00

Error Description/Action752 Printer sensed a mark in the wrong place. 753 Printer sensed a mark that is too long. 754 Check for a ribbon jam or remo

The factory default values are 9600 Baud, no parity, 8 bit data frame, 1 stop bit, and DTR flow control (9600, N, 8, 1, DTR). Set the communication v

Loading Labels or Tags 1. Open the cover. 2. Unlock the printhead by turning the retaining latch. 3. Lift printhead assembly using the printhead ta

5. Adjust the supply holder guides so the sides barely touch the roll. Make sure the supply roll turns freely. If you are using fan-fold supplies, p

5 10. Hold the printhead assembly by the printhead tab while pressing down on the printhead release. 11. Close the printhead by pressing down on t

2. Press down on the exit cover tabs to open the exit cover on the front of the printer. 3. Feed the backing paper over the peel bar. Lower Opening

When removing the backing paper, pull up across the saw-toothed tear edge. Make sure the backing paper tears at the edge. 5. Close the printer'

Loading Ribbon 1. Open the cover. 2. Unlock the printhead by turning the retaining latch. 3. Lift printhead assembly using the printhead tab until

Note: Make sure the “Monarch This End Out” writing is facing out. The ribbon roll only fits on the reel one way. 8. Carefully feed the ribbon unde